Chief PDR2243B Manuel d'installation télécharger pdf (Page 8)

PDR Series Installation Instructions

Figure 7

x 4

cable clamps

(J)

Cable Management

WARNING: IMPROPER INSTALLATION CAN LEAD TO

SERIOUS PERSONAL INJURY OR DAMAGE TO

EQUIPMENT! Make sure cables do not run through pinch

points.

1. Loosen front and rear cable clamps on top arm.

(See Figure 7)

2. Thread cable ties (J) under cable clamps and secure clamps

to top arm. (See Figure 7)

3. Route power/audio/video cables through the cable channel

in top arm (See Figure 7), allowing sufficient slack in cables

for left/Right movement of display and swing arm and also

swing arm extension and retraction.

4. Secure cables to top arm using two cable ties (J).

5. Repeat Steps 1 through 4, as necessary, for remaining top

arm and lower arms.

WARNING: IMPROPER INSTALLATION CAN LEAD TO

SERIOUS PERSONAL INJURY OR DAMAGE TO

EQUIPMENT! DO NOT route cables through holes in

faceplate.

Tension Adjustments

Vertical Tilt Tension Adjustment

1. With display mounted, check for desired vertical tilt tension.

2. Adjust the Centris Select knob until desired vertical tilt

tension is obtained. (See Figure 8)

3. To lock the mount at the desired vertical tilt, tighten the

vertical tilt lock screw. (See Figure 9)

Figure 8

Figure 9

Centris Select

Adjustment Knob

Vertical Tilt

Lock Screw

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Chief PDR2243B Manuel d'installation Page 8