Chief K2W22HB Manuel télécharger pdf (Page 8)

K2W Series Installation Instructions

Figure 1

(F) x 2

(E)

(G) x 2

set screw

side view

(A)

Assembly And Installation

Connecting K2W Series (wall mount) to Wall

1. Determine mounting location on wall.

2. Use a stud finder to locate 2" x 4" wood stud.

3. Use wall bracket (E) to mark and drill two 1/8” x 2 1/2” holes

in wall at desired mounting location. (See Figure 1)

IMPORTANT ! : Only top and bottom holes of wall

bracket (E) must be used to attach bracket to wall as

shown in Figure 1. Do NOT use any other holes to secure

bracket to wall!

4. Use two 1/4-2 1/2” hex head lag screws (F) and two 1/4”

washers (G) to install wall bracket (E) onto wall. (See

Figure 1)

IMPORTANT ! : Over tightening screws (F) may cause

bracket to compress into soft wall surface resulting in

difficult mount installation or improper engaging of set

screw in Step 6.

5. Hang monitor arm (A) over wall bracket. (See Figure 1)

6. Secure monitor arm to wall bracket by tightening set screw.

Ensure set screw engages back side of wall bracket (E) to

properly secure mount. (See Figure 1)

Array Installation (K2W21H and K2W22H

Models ONLY)

1. Slide rotational spacer (J10) into opening on array

attachment bracket. (See Figure 2)

2. Use 5/16-18 x 3" button head cap screw (J3), two thin steel

washers (J8), plastic spacer (J9), pocket washer (J5), pivot

pin (J4), pivot point spacer (J12) and 5/16-18 lock nut (J6)

to secure array (J1) to K2 arm (A). (See Figure 2)

NOTE: Cable clip (J11) can be used in place of pivot point

spacer (J12) if additional cable management is desired.

(See Figure 2)

Figure 2

(J10)

(J3)

(J9)

(J8) x 2

(J5)

(J1)

(J4)

(J6)

(A)

(J12)

(J11)

(K1W22H shown)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Chief K2W22HB Manuel Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Supports muraux pour écrans plats Chief K2W22HB