Chief K2W22HB Manuel télécharger pdf (Page 10)

K2W Series Installation Instructions

Figure 4

K2W21H/K2W22H

1. Remove quick release faceplate from mount by pulling

quick release lever and sliding faceplate off mount. (See

Figure 5)

Figure 5

2. Carefully place display face down on protective surface.

3. Connect faceplate to display

For flush mounting hole installation:

• Using Phillips screwdriver, carefully install four

M4x14mm screws (B) through corresponding

holes on faceplate and into the mounting holes on

the display. (See Figure 6)

Figure 6

For recessed mounting hole installation:

• Place four spacers (D) on top of mounting holes

on back of display. (See Figure 7)

• Using Phillips screwdriver, carefully install four

M4x25mm screws (C) through corresponding

holes on faceplate, spacers (D) and into the

mounting holes on the display. (See Figure 7)

Figure 7

(D) x 4

(A)

quick release lever

(B) x 4

quick release

faceplate

(for flush mounting holes)

(for recessed mounting holes)

(D) x 4

quick release

faceplate

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Chief K2W22HB Manuel Page 10