Chief SSC4 Manuel d'installation télécharger pdf

CHIEF MANUFACTURING INC. 8802-000130

1-800-582-6480 952-894-6280 FAX 952-894-6918 2004 Chief Manufacturing

12800 HIGHWAY 13 SOUTH, SUITE 500 www.chiefmfg.com

SAVAGE, MINNESOTA 55378 USA 01/04

INSTALLATION INSTRUCTIONS

BRACKET

SSC-4

The SSC bracket is designed for adding additional security to installations. By installing the SSC, a locking

device can be placed to obscure access to fastening hardware.

Unpack and check contents (see Figure 1):

(2) SSC-3 (5/16” clearance hole) (1) M4 Flat Washer

(3) SSC-1 (#10 clearance hole) (1) M5 Flat Washer

(1) 10-24 x .25” Phillips Head Cap Screw (1) M6 Flat Washer

(1) 5/16-18 x .625” Button Head Cap Screw (1) 3/16” Hex Key

1. Remove one of the 10-24 screws from the projector’s SLB interface bracket (see Figure 2).

2. Replace the 5/16” set screw of the RPA projector mount with the supplied 5/16” Button Head Cap

Screw and an SSC-3 (see Figure 3).

3. Install an SSC-1 bracket in one pitch and one roll adjustment screw on the RPA projector mount (see

Figure 4 & Figure 5).

Figure 2.

Figure 3.

Figure 1.

1 2

CHIEF MANUFACTURING INC. 8802-000130 1-800-582-6480 952-894-6280 FAX 952-894-6918 2004 Chief Manufacturing 12800 HIGHWAY 13 SOUTH, SUITE 500 www.ch

Page 2

4. Place an SSC-3 bracket on one of the mounting points of the SLB interface bracket (see Figure 6). Depending on the screw size, a flat wash

Pas de commentaire

Chief SSC4 Manuel d'installation