Chief RSA Series Manuel d'utilisateur télécharger pdf (Page 11)

Installation Instructions RSA Projector Mounts

Pitch Adjustment

1. Loosen pitch adjustment locking screw on each end

of the RSA projector mount using a #2 Phillips

screwdriver.

2. Adjust projector angle to desired pitch.

3. Tighten pitch adjustment locking screw on each end

of the RSA projector mount using a #2 Phillips

screwdriver.

ADJUSTMENTS

YAW Adjustment

1. Loosen yaw adjustment screw using a 5/32" hex

key.

NOTE: Yaw is only adjustable when attached to a

threaded pipe.

WARNING: Do not turn the projector to the end of

the pipe threads. The projector, interface plate and

projector will fall from the pipe if it is unthreaded too

far! A minimum of four threads must be engaged in

order to ensure a secure connection!

2. Adjust projector by turning the projector on the pipe

to the desired yaw position.

3. Tighten yaw adjustment locking screw using a 5/32"

hex key.

Example Only

(Interface bracket

varies dependent

on projector model)

Example Only

(Interface bracket

varies dependent

on projector model)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Chief RSA Series Manuel d'utilisateur Page 11