Chief FCA3X1U Manuel d'installation Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
Installation Instructions FCA2X1U-FCA3X1U-FCA3X1UP
7
Assembly And Installation
The following installation instructions assume that the LVM or
LBM Series video wall has been assembled prior to the point of
installing the rails to the columns. Refer to LVM or LBM Series
installation instructions for details.
Column Add-On Installation
1. Insert one column add-on (V) to each column (M) making
sure holes are lined up on each side. (See Figure 1)
2. Use 5/32" hex key (RR) and six 1/4-20 x 1/2" flat head cap
screws (X) to secure each column add-on (V) to each
column (M). (See Figure 1)
Figure 1
Rails Installation
1. Using display dimensions, determine where the center of
the top displays will be on the cart.
IMPORTANT ! : Install all column add-ons (V), if
applicable, prior to installing rails to columns.
2. Place clamp brackets (P) on column add-ons (V) in the
position of where the center of the top displays will be on the
cart with the diamond on the brackets being placed at the
exact center location. (See Figure 2)
Figure 2
3. Use 5/16-18 x 4 1/2" button head cap screw (FF), two 5/16"
washers (JJ) and 5/16-18" lock nut (NN) to secure each
clamp bracket (P) to column. (See Figure 2)
NOTE: Clamp brackets (P) may be flipped in order to use long
slots for installation if necessary. (See Figure 3)
Figure 3
4. Measure one screen height down from center point on
installed clamp brackets to determine mounting location of
lower clamp brackets. (See Figure 4)
5. Use 5/16-18 x 4 1/2" button head cap screw (FF), two 5/16"
washers (JJ) and 5/16-18" lock nut (NN) to install clamp
brackets for lower displays with center diamond one screen
height below center diamond of upper installed brackets.
(See Figure 4)
NOTE: If some clearance is desired in between displays, install
lower brackets slightly more than one screen height
below upper brackets.
Figure 4
6. Use four 5/16-18 x 3/4" button head flange screws (HH) to
secure each attached clamp bracket (P) to a quick connect
base (Q). (See Figure 5)
(rear view)
(V)
1
2
(X) x 6
(M)
(FCA3X1U shown)
2
2
(rear view)
(FF)
(NN)
3
3
(JJ) x 2
center of top displays
flipped bracket
(FF)
(NN)
5
5
(JJ) x 2
display
height
4
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire