Chief KSA1020 Manuel d'utilisateur télécharger pdf (Page 5)

Installation Instructions KSA-1020

ASSEMBLY

Installation of Protective Rubber Edging

1. Place four strips of protective rubber edging (C) over the

sharp edges located on the top and bottom of the mount (A).

(See Figure 1)

Figure 1

CPU Installation

1. Release bracket from mount by moving flag to open

position. (See Figure 2)

2. Remove bracket from mounting buttons on back of mount.

(See Figure 2)

Figure 2

3. If hanging mount underneath desk, remove mounting

buttons to reinstall them in the holes in which they will be

used.

• If mounting vertically, move mounting buttons to

the four holes on top of the mount. (See Figure 3)

• If mounting horizontally, move mounting buttons

to the top four holes on the back. (See Figure 3)

Figure 3

4. Loosen adjustment knob at the back of the mounting unit

and adjust height of mount to a height greater than the

height of the CPU. Loosen strap at the front of the mount if

necessary. (See Figure 4)

Figure 4

(A)

Latch open

Latch closed

Vertical button location

Horizontal button location

Strap

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Chief KSA1020 Manuel d'utilisateur Page 5