Chief ERD8-12-16-20 Manuel d'utilisateur télécharger pdf (Page 5)

Installation Instructions ERD Series

ASSEMBLY

IMPORTANT ! : The following installation instructions

assume the ER rack has already been completely

assembled. Complete ER rack assembly following ER

rack installation instructions prior to installing the ERD

door.

IMPORTANT ! : The ERD doors were designed

specifically to be installed to the front of the ER racks. Do

NOT attempt to install this door to any other rack or

mounting device.

NOTE: The hinge member that attaches to the front edge of the

rack is the same width and height as the rack and

should be lined up as such.

1. Measure and mark 1" from the top and bottom of the edge

on what will be the hinge side of the door. (See Figure 1)

NOTE: Door can be connected on either side depending on

user preference.

2. Drill a 1/16" hole, 1/2" in depth, at each of these marked

locations. (See Figure 1)

3. Use two #10 x 5/8" Phillips pan wood screws (D) to attach

door (A) at drilled hole locations. (See Figure 1)

Figure 1

4. Drill 1/16" holes, 1/2" in depth, at remaining hole locations.

(See Figure 2)

5. Install one #10 x 5/8" Phillips pan wood screw (D) in each

drilled hole location to fully secure door (A) to rack. (See

Figure 2)

6. Install four nail glides (B) on underside of rack in order to

allow door to swing freely above ground. (See Figure 2)

7. Close door (A). (See Figure 2)

Figure 2

8. With door closed, turn the lock so that the "cam" ("L" shaped

part of lock) is horizontal.

9. Position lock bracket (C) over cam making sure the cam can

clear the bracket when turned completely from locked to

unlocked position.

10. Mark the location of the two holes on the lock bracket (C).

(See Figure 3)

11. Drill two 1/16" holes, 1/2" in depth, at these marked

locations. (See Figure 3)

12. Use two #10 x 5/8" Phillips pan wood screws (D) to attach

lock bracket (C) to rack. (See Figure 3)

Figure 3

1/16"

1 2

(A)

(D) x 2

(ERD-12 shown)

1/2"

from edge

(B) x 4

1/16"

(D)

(C)

(D) x 2

1/16"

10 11

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Chief ERD8-12-16-20 Manuel d'utilisateur Page 5

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Chief ERD8-12-16-20